Drag Finisher Tooling Fixtures

These “Quick Release” tool holders use standard R8 collets and are mounted directly to our Driven 3rd axis holders. Load the cutting tools directly into the holder for high productivity.

These driven 3rd axis tool holders are designed to add additional g-force to the motion of the drag finisher, resulting in shorter process times. These holders are easy to install, and are designed for use with our bayonet style collets. Replacement parts are readily available and in stock. See below for collet information.

Our standard collets are for use with the free-wheeling tool holders. The tool is held in place by a simple hex-head screw against the tool shank. The collet is fastened to the tool by a button head screw through the bearing inner race. Brass sleeves are available, in increments, to minimize the number of collets required.

This range of collets is designed for use with our driven tool holders. Tools are held in place by a simple hex head screw against the tool shank, and the collet is mounted to the tool holder by a push and twist bayonet-like action.

This “Bayonet Mount” range of collets is designed for use with our bayonet style tool holders. A three-jaw quick chuck holds the tool against the tool shank, and the collet is mounted to the tool holder by a bayonet style, push and turn system for quick mounting.

This “Direct Spline’ style tool holder is used for extra large shank, cutting tools that are outside the scope of a quick chuck and bayonet style tool holders. Simple load and unload pull pin locking mechanism.