Most wet vibratory and barrel-finishing processes use a properly diluted liquid or powder compound. The compound works with the media, water, parts, and equipment to help control the overall process.
Depending on its formulation, a finishing compound may:
- Keep the parts and media clean
- Suspend oils, soils, and removed material
- Flush process residue from the working area
- Provide lubrication so parts can move without sticking or galling
- Help prevent media glazing
- Control foam
- Brighten certain metals
- Provide temporary corrosion protection
- Support consistent results from batch to batch
Compound selection should match the part material and intended process. Some metals can discolor or react unfavorably when exposed to an unsuitable acidic or alkaline formulation. Different stages of a multi-step process may also require different compound characteristics.
Compound delivery depends partly on the equipment:
- Batch processing: A measured quantity of water and compound remains with the load during the cycle and is discharged when processing is complete.
- Flow-through processing: Fresh water and compound enter continuously while used solution and suspended residue leave the working chamber.
Using too much compound can cause excessive foam or alter the processing action. Using too little may allow oils and residue to accumulate, reduce lubrication, encourage thin or flat parts to stick together, or interfere with media performance. Follow the recommended concentration and operating instructions for the specific formulation.
Dry polishing and dry deburring operate differently. Corn cob, walnut shell, wood, and other dry media may use a compatible abrasive, polishing paste, powder, or liquid additive. These additives generally remain in the media and are replenished according to process requirements and finishing results.