Tumbling Media

Media Type - Plastic

Media Type - Ceramic

Manufactured to our own formulated specifications, containing only the finest raw materials available. Low and High density plastic media is used within the metal industry for surface preparation and improvement on most metals such as aluminum, brass, copper, and zinc as well as plastic. Bel Air has a wide selection of High and Low Density plastic and synthetic tumbling media in a variety of sizes and shapes. Click the picture for more information, and to download our brochure.

Manufactured to our own formulated specifications, containing only the finest raw materials available. Bel Air Ceramic media is used within the metal and plastics finishing industry for surface preparation and improvement on most metals such as steel, stainless steel, and other hard metals and materials. As ceramic media has a higher density than plastic, very aggressive material removal can be obtained in short time cycles.

Media Type - Dry Polishing

Media Type - Precision

DRY MEDIA has been developed over years of production experience. The main initiative has been to eliminate the associated problems of product waste water. There are several main factors that we address to choose the correct media with the best performance. CUT is the factor that determines the ability to deburr or reduce rough surfaces. COLOR is the factor that determines the ability to brighten or polish the work piece. Size and density relate to the efficiency of the process.

Manufactured to our own formulated specifications, containing only the finest raw materials available. Precision media is used within the metal industry for surface preparation and improvement on most metals such as aluminum, brass, copper, and zinc as well as plastic. Precision media will achieve deburring & polishing in the finest geometries. Fine finishes as well as aggressive cutting can be achieved.

Media Type - Wet Burnishing

Compounds

Bel Air steel and stainless steel finishing media are ideal for deburring, descaling, deflashing metal and plastic, removing die lines, pre-plate finishing, degreasing, cleaning and burnishing. When used in finishing equipment, stainless steel media actually improves part surfaces and provides substantial operating economies over other manufacturing methods.

Manufactured to our own formulated specifications, containing only the finest raw materials available. Compounds are an integral part of a finishing process. Keeping the process media and parts clean by suspending the contaminants and metals in the process solution while still being treatable is important. Lubricating and protecting the metals from oxidation for the tumbling compounds and ultrasonics are key factors in a good process. For burnishing, wet grinding and rust preventatives are employed.